Hi,
I updated NVM and used qcu for configuring Intel XL710QDA2 to 4x10 mode.
This adapter has two 40Gb ports.
However the qcu displayed that the adapter doesn’t support configuration modification as below.
How can I config to support 4x10 mode with this adapter?
Thanks,
Iris
I'd like to set up Intel XL710
[root@centos12 Linux_x64]# ethtool -i eth8
driver: i40e
version: 1.3.47
firmware-version: 4.42 0x80001932 0.0.0
bus-info: 0000:08:00.0
supports-statistics: yes
supports-test: yes
supports-eeprom-access: yes
supports-register-dump: yes
supports-priv-flags: yes
[root@centos12 Linux_x64]#
[root@centos12 qcu]# ./qcu64e /devices
Intel(R) QSFP+ Configuration Utility
QCU version: v1.24.35.01
Copyright(C) 2015 by Intel Corporation.
Software released under Intel Proprietary License.
NIC B:D Ven-Dev Mode Adapter Name
=== ===== ========= ====== ====================================================
1) 08:00 8086-1583 N/A Intel(R) Ethernet Converged Network Adapter XL710-Q2
[root@centos12 qcu]# ./qcu64e /nic=1 /info
Intel(R) QSFP+ Configuration Utility
QCU version: v1.24.35.01
Copyright(C) 2015 by Intel Corporation.
Software released under Intel Proprietary License.
QSFP+ Configuration modification is not supported by this adapter.
[root@centos12 qcu]#