Problems of IPv6+UDP/TCP, IPv4 and IPv6 RSS on XL710 NIC
The Fodora 20 system was installed with quad-port XL710 NIC. By default, the NIC driver creates 4 queues per port and both IPv4+UDP/TCP(udp4/tcp4) and IPv6+UDP/TCP(udp6/tcp6) for RSS are enabled. It...
View ArticleRe: Which Intel NICs support hardware timestamps (hardstamps)
Hi Darneas, The I340 and I350 Server adapter (Please refer to product brief) supports IEEE 1588. 1) I340 series server adapter...
View ArticleRe: Intel 10Gbit Card X540-T1 changes its Hardware ID?
Hi Adam_Crouch, Thank you for the additional info provided. We will check on this. rgds,wb
View ArticleRe: Determine SFP module serial number from ixgbe driver?
I figured it out. You can extract the serial number from the SFP interface by running ethtool's EEPROM dump command, with the 'raw' extension:$ ethtool -m eth0 raw on
View ArticleClik here to view.
Re: Problems of IPv6+UDP/TCP, IPv4 and IPv6 RSS on XL710 NIC
Hi lscom, Thanks for your post. I'll check on this. Sincerely, Sandy
View ArticleClik here to view.
Re: Problems of IPv6+UDP/TCP, IPv4 and IPv6 RSS on XL710 NIC
Hi lscom,Please update the firmware and driver of the XL710 Card. You may download the firmware and driver below: 1. Intel Ethernet Drivers and Utilities - Browse /i40e stable/1.3.39.1 at...
View ArticleIntel I217/I218 issues with wake on lan
Having issues with the Intel I217 LM and I218 LM using WOL. It wakes up just fine after going to sleep for a few minutes or right after shutdown but if I leave the unit overnight and attempt a wake up...
View ArticleIntel I217/I218 Wake On Lan Not Working
On these two network adapters the wake on lan IS working if the unit goes to sleep/hibernate/off and you wake up within a few minutes. If you leave it to sleep/hibernate/off and try to wake up after...
View ArticleRe: Intel I217/I218 Wake On Lan Not Working
It is not adapters, just PHY chips, so wake-up capabilities depends on motherboard, chipset and BIOS, also on PSU (+5VSB stand-by power). So, what motherboards do you have issues with?
View ArticleRe: Intel I217/I218 Wake On Lan Not Working
These are HP motherboards, the 2215, 2216, 2255. The 221C works and the only difference is that is has a Realtek adapter.
View ArticleClik here to view.
Re: Problems of IPv6+UDP/TCP, IPv4 and IPv6 RSS on XL710 NIC
Hi Sandy, I tried ./nvmupdate64e -l XL710_update.log and ./nvmupdate64e -l XL710_update.log -o XL710.xml -b -c nvmupdate.cfg and It failed to update firmware.The message is shown below: Intel(R)...
View ArticleRe: Intel I217/I218 issues with wake on lan
Hi intelnicnotworking, Thank you for the post. I see you post another same post, we will check it from there. rgds,wb
View ArticleRe: Intel I217/I218 Wake On Lan Not Working
Hi Intelnicnotworking, Please check in the BIOS if there is any wake on lan option need to enable. Have you also contact the motherobard vendor regarding this issue as this is onboard NIC. rgds,wb
View ArticleRe: 82566 MM gigabit link down
Thanks, I solved it but with an older driver (2010). ...and about the newest driver, your link points to PROWinx64.exe (intel driver update utility) which, after instalation, is finding the 2013...
View ArticleRe: X710 dropping LLDP frames ?
Hello Sandy, Same result when installing and enabling some settings thanks to LLDPAD.LLDP RX frames are never seen from OS side .. Here what I do (after installing and starting lldpad): # dmesg | grep...
View ArticleRe: X710 dropping LLDP frames ?
LLDP is meant to be handled directly on the NIC in the X710, and the firmware defaults to this feature being on. You can work around the issue (at least under linux) using# echo lldp stop >...
View ArticleRe: X710 dropping LLDP frames ?
Great, it's working now.Perhaps Intel should put this in a documentation somewhere ... ? Thank you jbrandeb ! :-)
View ArticleRe: Problems of IPv6+UDP/TCP, IPv4 and IPv6 RSS on XL710 NIC
Hi lscom, Nope. EEPID should not be an issue updating the firmware. However, you may try to load the older version (ver 1.0) first then the latest version (ver 1.25). See below: 1....
View ArticleRe: VLAN tag inside NVGRE tunnel getting stripped by XL710 (i40e)
Hi, we have pushed a fix upstream that repairs this issue:https://git.kernel.org/cgit/linux/kernel/git/davem/net.git/commit/?id=c4bbac3913c0d649898a0d767728a585869a7d7d he 1.3.46 driver released on...
View ArticleRe: Intel 10Gbit Card X540-T1 changes its Hardware ID?
Hi Adam Crouch, Just to double check if you have tried below latest driver version 20.4? Please feel free to update me the result. Thank you.Download Network Adapter Driver for Windows Server 2012...
View Article